Home Products

Programmers

PRESTO FORTE

Logic analyzers

SIGMA2 OMEGA

USB products

UCAB232 UCAB232i

Other products Museum

Electronic Design Sales & Prices Support About us Contact

PRESTO supports wide range of devices:

• Microchip PIC^®, dsPIC/PIC24^® and PIC32^® MCUs
  Serially programmable devices (all Flash and the most popular OTP/JW).
• Microchip/Atmel AVR^® and 8051 architecture MCUs
  Devices with SPI low voltage serial downloading - for example ATtiny12, AT90S8535, ATmega128 and AT89S51. AVR devices with the TPI interface - e.g. ATtiny10.
• Texas Instruments MSP430^® and CC430^® MCUs
  (Security Fuse blowing and Bootstrap loader memory programming is not supported).
• Chipcon/Texas Instruments CCxxxx^® MCUs
• Cypress/Infineon PSoC^® MCUs
  CY8C21xx, CY8C24xx and CY8C27xx.
• Components with JTAG interface
  - types which can be programmed using SVF or XSVF file - for example
  • CPLDs - AMD/Xilinx (XC95xx, CoolRunner, ...), Intel/Altera, Lattice and others
  • FPGA configuration Flash PROMs - Xilinx (XC18Vxx, XCFxxS)
  • Microchip/Atmel ATmega
• Serial EEPROM and Flash memories
  
  • I²C (24LCxx)
  • Microwire (93LCxx)
  • SPI EEPROM (25Cxx)
  • SPI Flash EPROM (M25Pxx, M45PExx, ...)

The  ➜ complete list of devices supported by the program UP  with comparison chart for all ASIX programmers.

Note for low-voltage versions of Microchip parts: The programming algorithm for the PIC...LF... devices is the same as for the PIC...F... devices. So, when you need to program e.g. the PIC18LF2420 chip, select the PIC18F2420 device.

If you need to program a device not listed here, please contact us and, if PRESTO is able to support the device, we will implement it. Addition of any part manufactured by the vendors listed above is free in most cases, sometimes we will charge you a moderate fee.

OBSOLENCE NOTES

• 32-bit ARM-based MCUs by various vendors
  Software ARMINE using OpenOCD is obsolete, for support of ARM devices please use the FORTE programmer.

• Cyan Technology eCOG1
  OBSOLETE - THESE DEVICES ARE NO LONGER AVAILABLE.
  eCOG1 Programmer software - including basic debug control via eICE interface (Run, Stop, Reset).